Did water ingress cause a boot catch fault on my Mini Cooper?

Can you give me some advice and possibly point me in the right direction of which way to proceed with a problem with my 2009 Mini Cooper cabriolet that I have had from new. The car has been serviced by the BMW Mini dealership since new. Just over a year ago I noticed there was a small plastic component sticking out of the side of the hood. I immediately returned the car to the service dept at Chandlers MINI and they confirmed the part was integral to the hood and as a result the entire canvas cover would need replacing. Unfortunately they were unable to source a hood in the UK and I had to wait around 4 weeks for a replacement to arrive from Germany.

During that time it rained pretty much non-stop and as a result the boot of the car filled with water. The carpeting in the boot went mouldy. As soon as the hood arrived I took the car to Chandlers for it to be fitted. They had to keep the car overnight to dry it out. All the carpeting was beyond repair so that was also replaced under the the warranty.

Move forwards to just over a year. The boot on the car now randomly opens. Also when I lock the car I can sometimes hear the boot catch continually trying to open and close. It is an intermittent fault. My car was due its service last week so I booked it into BMW and asked them to also look at the fault with boot at the same time. I took a call Tuesday afternoon to say the mechanics had never seen anything like it. Apparently all the components in the boot have corroded. I told them to refer to their records and they would see the boot sat in water for around four weeks whilst I waited for a replacement hood. Whilst they accept this happened they cannot agree that this would have caused the components to corrode in the way that they have. Is it usual for electrical components on a car to rust in this way?

Asked on 23 March 2013 by KH, via email

Answered by Honest John
The boot of a MINI convertible is an enclosed compartment, so if there is water ingress the moisture will condense and re-condense on the walls of the compartment, saturating the trim and the electrical components behind it. I would say that the corrosion of the components there is entirely consequential of the leak and the delay in fixing that leak and that at least some liability rests with the dealer.

Update: The dealer capitulated.
Similar questions
You wrote: “This generation of Corsa can suffer water ingress because the brake master cylinder is bolted to a plate that is bonded to the bulkhead. This bonding fails, allowing water in". I spoke to...
I bought my new Puma in October 2020. At the two year service, I was advised the rear discs were badly pitted and corroded, and as I noticed some uncomfortable braking, I had new rear discs and pads at...
I bought a second-hand Dodge (2008 model) around four months ago. The car was sold with a new MoT which had an advisory foe the rear subframe (corroded but not seriously weakened). This week the axle...