FIAT Scudo MOT Results

Registered in 1999
58.2% pass rate
from 170 tests in 2020
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 1999 vans and highlighted areas where the FIAT Scudo is unusually good or bad.

  • 18% fail on Suspension
    • 5.9% fail on Suspension arms
      • 2.9% fail on Ball joint
      • 2.4% fail on Ball joint dust cover
      • 0.59% fail on Pins and bushes
    • 4.7% fail on Component mounting prescribed areas
    • 4.1% fail on Sub-frames (3 times worse than other 1999 vans)
      • 2.4% fail on Sub-frame mounting prescribed areas
      • 1.2% fail on Sub-frame (7 times worse than other 1999 vans)
      • 0.59% fail on Pins and bushes
      • 0.59% fail on Ball joint
    • 3.5% fail on Shock absorbers (2 times worse than other 1999 vans)
    • 2.4% fail on Springs
      • 1.8% fail on Coil springs
        • 1.8% fail on Coil spring
      • 0.59% fail on Spring mounting prescribed areas
    • 1.8% fail on Axles (11 times worse than other 1999 vans)
      • 1.2% fail on Swivel pins and bushes (35 times worse than other 1999 vans)
      • 0.59% fail on Axle
    • 1.2% fail on Anti-roll bars
      • 0.59% fail on Anti-roll bar
      • 0.59% fail on Linkage pins and bushes
    • 1.2% fail on Other suspension component
      • 0.59% fail on Other suspension component
      • 0.59% fail on Ball joint
    • 0.59% fail on Wheel bearings
  • 17% fail on Brakes
    • 10% fail on Brake performance
      • 6.5% fail on Service Brake Efficiency (sp)
        • 5.9% fail on Rbt (sp)
          • 4.7% fail on Service brake imbalance
          • 1.8% fail on Service brake performance
        • 0.59% fail on Plate brake tester (sp)
          • 0.59% fail on Service brake imbalance
      • 4.7% fail on Service brake performance
        • 4.7% fail on Rbt
          • 4.1% fail on Service brake performance
          • 0.59% fail on Service brake imbalance
      • 2.4% fail on Parking brake performance
        • 2.4% fail on Rbt
          • 1.8% fail on Parking brake performance
          • 0.59% fail on Parking (secondary brake performance)
      • 1.8% fail on Parking brake efficiency (sp)
        • 1.8% fail on Rbt (sp)
    • 4.7% fail on Rigid brake pipes
    • 3.5% fail on Mechanical brake components
      • 2.4% fail on Brake discs and drums
        • 2.4% fail on Brake discs
      • 1.2% fail on Brake linings and pads
        • 1.2% fail on Brake pads
      • 0.59% fail on Brake cables, rods, levers and linkages
        • 0.59% fail on Lever
    • 0.59% fail on Flexible brake hoses
    • 0.59% fail on Load sensing valves
  • 14% fail on Lamps, reflectors and electrical equipment
    • 4.7% fail on Stop lamp
    • 2.4% fail on Registration plate lamp(s)
    • 1.8% fail on Headlamp aim
      • 1.8% fail on Headlamp aim
    • 1.8% fail on Position lamps
      • 1.8% fail on Position lamp
    • 1.8% fail on Electrical equipment
      • 1.2% fail on Horn
      • 0.59% fail on Battery(ies)
    • 1.2% fail on Headlamps
      • 1.2% fail on Headlamp
    • 1.2% fail on Direction indicators
      • 1.2% fail on Flashing type
        • 0.59% fail on Side repeaters
        • 0.59% fail on Switch
    • 1.2% fail on Front and rear fog lamps
      • 1.2% fail on Rear fog lamp
        • 1.2% fail on Rear fog lamp
  • 12% fail on Body, chassis, structure
    • 5.3% fail on Exhaust system
    • 5.3% fail on Transmission
      • 4.1% fail on Drive shafts
        • 4.1% fail on Joints
      • 0.59% fail on Prop shafts
        • 0.59% fail on Joints
      • 0.59% fail on Belts
    • 1.8% fail on Integral vehicle structure
      • 1.8% fail on Integral vehicle structure condition
    • 1.2% fail on Fuel system
      • 1.2% fail on Pipe
    • 0.59% fail on Bumpers
    • 0.59% fail on Towbar
      • 0.59% fail on Vehicle structure
    • 0.59% fail on Body
      • 0.59% fail on Other body component
  • 8.8% fail on Visibility
    • 5.9% fail on Wipers
    • 2.4% fail on Washers
    • 1.2% fail on View to rear
      • 1.2% fail on Mirrors
    • 0.59% fail on Condition of glass
      • 0.59% fail on Windscreen
  • 7.1% fail on Steering
    • 4.1% fail on Steering linkage components
      • 3.5% fail on Track rod end
      • 0.59% fail on Ball joint
    • 3.5% fail on Steering gear
      • 2.9% fail on Steering rack
      • 0.59% fail on Operation
    • 0.59% fail on Power steering
      • 0.59% fail on Other components
  • 7.1% fail on Tyres
    • 4.7% fail on Tread depth
    • 2.4% fail on Condition
  • 1.8% fail on Seat belts and supplementary restraint systems
    • 1.8% fail on Seat belts
      • 1.8% fail on Condition
  • 1.8% fail on Noise, emissions and leaks
    • 1.8% fail on Exhaust emissions
      • 1.8% fail on Compression ignition
        • 1.8% fail on Pre 01/07/2008 Turbo