MOT Results

Honest John Vans MOT Results » Toyota » Dyna » 2011

Toyota Dyna MOT Results

Registered in 2011
55.4% pass rate
from 148 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 2011 vans and highlighted areas where the Toyota Dyna is unusually good or bad.

  • 21% fail on Lamps, reflectors and electrical equipment
    • 7.4% fail on Stop lamp
    • 6.8% fail on Front and rear fog lamps (2 times worse than other 2011 vans)
      • 6.8% fail on Rear fog lamp (2 times worse than other 2011 vans)
        • 6.8% fail on Rear fog lamp (2 times worse than other 2011 vans)
    • 4.7% fail on Registration plate lamp(s)
    • 3.4% fail on Headlamp aim
      • 3.4% fail on Headlamp aim
    • 2.7% fail on Headlamps
      • 2.7% fail on Headlamp
    • 1.4% fail on Reversing lamps
      • 1.4% fail on Reversing lamps
    • 0.68% fail on Direction indicators
      • 0.68% fail on Flashing type
        • 0.68% fail on Individual direction indicators
    • 0.68% fail on Hazard warning
      • 0.68% fail on Switch
  • 20% fail on Brakes
    • 11% fail on Brake performance
      • 8.1% fail on Service Brake Efficiency (sp) (7 times worse than other 2011 vans)
        • 8.1% fail on Rbt (sp) (7 times worse than other 2011 vans)
          • 6.1% fail on Service brake imbalance (13 times worse than other 2011 vans)
          • 5.4% fail on Service brake performance (8 times worse than other 2011 vans)
      • 6.1% fail on Parking brake efficiency (sp)
        • 6.1% fail on Rbt (sp)
      • 3.4% fail on Service brake performance
        • 2.7% fail on Rbt
          • 2.0% fail on Service brake performance
          • 0.68% fail on Service brake imbalance
        • 0.68% fail on Plate brake tester
          • 0.68% fail on Service brake efficiency (Trikes, quads and pre-68 vehicles)
    • 4.1% fail on Mechanical brake components
      • 3.4% fail on Brake linings and pads
        • 3.4% fail on Brake pads
      • 0.68% fail on Brake cables, rods, levers and linkages
        • 0.68% fail on Clevis joint
    • 3.4% fail on ABS / EBS / ESC
      • 3.4% fail on Anti-lock braking system (2 times worse than other 2011 vans)
    • 2.7% fail on Rigid brake pipes
    • 0.68% fail on Parking brake control
      • 0.68% fail on Lever
    • 0.68% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 0.68% fail on Hydraulic brake cylinder
    • 0.68% fail on Load sensing valves
  • 16% fail on Suspension
    • 8.8% fail on Springs
      • 8.1% fail on Leaf springs (4 times worse than other 2011 vans)
        • 8.1% fail on Leaf spring (6 times worse than other 2011 vans)
      • 0.68% fail on Coil springs
        • 0.68% fail on Coil spring
    • 7.4% fail on Anti-roll bars
      • 5.4% fail on Pins and bushes (4 times worse than other 2011 vans)
      • 0.68% fail on Anti-roll bar
      • 0.68% fail on Attachment bracket and mounting
      • 0.68% fail on Linkage
      • 0.68% fail on Linkage pins and bushes
    • 1.4% fail on Wheel bearings
    • 0.68% fail on Suspension arms
      • 0.68% fail on Ball joint
    • 0.68% fail on Component mounting prescribed areas
  • 14% fail on Visibility
    • 8.1% fail on Washers
    • 6.8% fail on Wipers
    • 2.0% fail on Condition of glass
      • 2.0% fail on Windscreen
    • 2.0% fail on View to rear
      • 2.0% fail on Mirrors
  • 7.4% fail on Body, chassis, structure
    • 3.4% fail on Body (7 times worse than other 2011 vans)
      • 2.7% fail on Panel (31 times worse than other 2011 vans)
      • 0.68% fail on Body condition
    • 2.0% fail on Fuel system
      • 1.4% fail on Tank (9 times worse than other 2011 vans)
      • 0.68% fail on Fuel cap/sealing device
    • 0.68% fail on Exhaust system
    • 0.68% fail on Transmission
      • 0.68% fail on Belts
    • 0.68% fail on Seats
      • 0.68% fail on Passenger's seat
  • 6.8% fail on Tyres
    • 4.1% fail on Tread depth
    • 2.7% fail on Condition
  • 5.4% fail on Noise, emissions and leaks
    • 4.7% fail on Exhaust emissions
      • 4.7% fail on Compression ignition
        • 4.1% fail on Malfunction indicator lamp
        • 0.68% fail on Emissions not tested
    • 0.68% fail on Fluid leaks
      • 0.68% fail on Transmission oil leaks
  • 2.0% fail on Identification of the vehicle
    • 2.0% fail on Registration plates
  • 2.0% fail on Steering
    • 2.0% fail on Steering linkage components
      • 2.0% fail on Track rod end
  • 0.68% fail on Road Wheels
    • 0.68% fail on Attachment