MOT Results

Honest John Vans MOT Results » FIAT » Scudo » 2000

FIAT Scudo MOT Results

Registered in 2000
48.3% pass rate
from 236 tests in 2021
More MoT Results
Failure rates by item

Here you can drill down into the failure rates for each item on the test. We've also compared the rates to the average results for 2000 vans and highlighted areas where the FIAT Scudo is unusually good or bad.

  • 25% fail on Suspension
    • 9.7% fail on Component mounting prescribed areas
    • 9.3% fail on Suspension arms (93% worse than other 2000 vans)
      • 7.2% fail on Ball joint (160% worse than other 2000 vans)
      • 3.0% fail on Pins and bushes (2 times worse than other 2000 vans)
      • 1.3% fail on Ball joint dust cover
    • 5.1% fail on Sub-frames (3 times worse than other 2000 vans)
      • 3.0% fail on Sub-frame mounting prescribed areas (200% worse than other 2000 vans)
      • 1.7% fail on Sub-frame (9 times worse than other 2000 vans)
      • 0.42% fail on Attachment bracket and mounting
    • 1.3% fail on Springs
      • 1.3% fail on Coil springs
        • 1.3% fail on Coil spring
    • 0.85% fail on Axles (6 times worse than other 2000 vans)
      • 0.85% fail on Swivel pins and bushes (15 times worse than other 2000 vans)
    • 0.85% fail on Macpherson strut
      • 0.85% fail on Attachment bracket and mounting (8 times worse than other 2000 vans)
    • 0.85% fail on Other suspension component
      • 0.42% fail on Pins and bushes
      • 0.42% fail on Ball joint dust cover
    • 0.42% fail on Wheel bearings
    • 0.42% fail on Shock absorbers
    • 0.42% fail on Suspension rods
      • 0.42% fail on Suspension rod
  • 19% fail on Lamps, reflectors and electrical equipment
    • 5.9% fail on Direction indicators
      • 5.9% fail on Flashing type
        • 4.7% fail on Individual direction indicators
        • 1.7% fail on Side repeaters
    • 5.1% fail on Headlamps
      • 4.7% fail on Headlamp
      • 0.42% fail on Headlamp levelling device
    • 4.2% fail on Headlamp aim
      • 3.4% fail on Headlamp aim
      • 0.85% fail on Headlamp aim not tested
    • 3.8% fail on Stop lamp
    • 3.0% fail on Registration plate lamp(s)
    • 3.0% fail on Electrical equipment
      • 2.1% fail on Horn
      • 0.85% fail on Battery(ies)
    • 0.42% fail on Position lamps
      • 0.42% fail on Position lamp
    • 0.42% fail on Hazard warning
      • 0.42% fail on Switch
  • 17% fail on Body, chassis, structure
    • 8.1% fail on Exhaust system (100% worse than other 2000 vans)
    • 5.5% fail on Transmission
      • 5.5% fail on Drive shafts
        • 5.5% fail on Joints
    • 3.0% fail on Chassis
      • 3.0% fail on Chassis condition
    • 2.1% fail on Integral vehicle structure
      • 2.1% fail on Integral vehicle structure condition
      • 0.42% fail on Sub-frame
        • 0.42% fail on Sub-frame condition
    • 0.85% fail on Fuel system
      • 0.85% fail on Pipe
    • 0.42% fail on Body
      • 0.42% fail on Panel
    • 0.42% fail on Floor
    • 0.42% fail on Seats
      • 0.42% fail on Driver's seat
  • 14% fail on Brakes
    • 8.1% fail on Brake performance
      • 4.2% fail on Service brake performance
        • 4.2% fail on Rbt
          • 3.8% fail on Service brake performance
          • 0.85% fail on Service brake imbalance
      • 3.8% fail on Service Brake Efficiency (sp)
        • 3.8% fail on Rbt (sp)
          • 2.5% fail on Service brake performance
          • 1.7% fail on Service brake imbalance
      • 2.1% fail on Parking brake efficiency (sp)
        • 2.1% fail on Rbt (sp)
      • 0.42% fail on Parking brake performance
        • 0.42% fail on Rbt
          • 0.42% fail on Parking brake performance
    • 3.4% fail on Mechanical brake components
      • 1.7% fail on Brake discs and drums
        • 1.7% fail on Brake discs
      • 1.3% fail on Brake linings and pads
        • 1.3% fail on Brake pads
      • 0.42% fail on Brake cables, rods, levers and linkages
        • 0.42% fail on Cable
    • 3.0% fail on Rigid brake pipes
    • 3.0% fail on Load sensing valves
    • 0.42% fail on Parking brake control
      • 0.42% fail on Lever
    • 0.42% fail on Hydraulic systems
      • 0.42% fail on Brake fluid
    • 0.42% fail on Brake actuators (including spring brakes or hydraulic cylinders)
      • 0.42% fail on Air brake cylinder/actuator
    • 0.42% fail on Other components and prescribed areas
      • 0.42% fail on Other components
  • 12% fail on Visibility
    • 7.2% fail on Washers
    • 5.9% fail on Wipers
  • 8.9% fail on Steering
    • 4.7% fail on Steering gear
      • 4.7% fail on Steering rack
    • 4.2% fail on Steering linkage components
      • 2.5% fail on Track rod end
      • 1.3% fail on Ball joint
      • 0.42% fail on Locking devices
    • 1.3% fail on Power steering
      • 0.85% fail on Other components
      • 0.42% fail on Pipes and hoses
  • 6.8% fail on Tyres
    • 4.2% fail on Condition
    • 3.4% fail on Tread depth
  • 2.5% fail on Seat belts and supplementary restraint systems
    • 2.5% fail on Seat belts
      • 1.3% fail on Condition
      • 0.85% fail on Requirements (5 times worse than other 2000 vans)
      • 0.42% fail on Prescribed areas
  • 2.5% fail on Noise, emissions and leaks
    • 2.1% fail on Exhaust emissions
      • 1.3% fail on Spark ignition
        • 0.85% fail on Emissions not tested
        • 0.42% fail on Malfunction indicator lamp
      • 0.85% fail on Compression ignition
        • 0.85% fail on Emissions not tested
        • 0.42% fail on Pre 01/07/2008 Turbo
    • 0.42% fail on Fluid leaks
      • 0.42% fail on Engine oil leaks
  • 1.3% fail on Identification of the vehicle
    • 1.3% fail on Registration plates